33: Configuring a GRE interface
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 310 of 350
33.3 GRE configuration using command line
The configuration file is stored on /etc/config/network
For the examples below tunnel1 is used as the interface logical name.
33.4 GRE configuration using UCI
root@VA_router:~# uci show network
network.tunnel1=interface
network.tunnel1.proto=gre
network.tunnel1.monitored=0
network.tunnel1.ipaddr=172.255.255.2
network.tunnel1.mask_length=24
network.tunnel1.local_interface=wan
network.tunnel1.remote_ip=172.255.255.100
network.tunnel1.ttl=128
network.tunnel1.key=1234
network.tunnel1.mtu=1472
network.tunnel1.auto=1
33.5 GRE configuration using package options
root@VA_router:~# uci export network
config interface 'tunnel1'
option proto 'gre'
option monitored ‘0’
option ipaddr '172.255.255.2'
option mask_length '24'
option local_interface 'wan'
option remote_ip ‘172.255.255.100’
option ttl '128'
option key '1234'
option mtu '1472'
option auto ‘1’
To change any of the above values use uci set command.
To Next Page
Loading...
Need help?
General