24: Configuring Multi-WAN
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 184 of 350
24.3 Multi-WAN traffic rules
You can also set up traffic rules, to forward specific traffic out of the right WAN interface,
based on source, destination address, protocol or port. This is useful to force traffic on
specific interfaces when using multiple WAN interfaces simultaneously.
Figure 98: The multi-WAN traffic rules page
24.4 Configuring Multi-WAN using UCI
Multi-WAN UCI configuration settings are stored on /etc/config/multiwan
Run UCI export or show commands to see multiwan UCI configuration settings. A sample
is shown below.
root@VA_router:~# uci export multiwan
package multiwan
config multiwan 'config'
option preempt 'yes'
option alt_mode 'no'
option enabled 'yes'
config interface 'wan'
option disabled '0'
option health_interval '10' option health_fail_retries '3'
option health_recovery_retries '5'
option priority '2'
option manage_state 'yes'
option exclusive_group '0'
option ifup_retry_sec '40'
option icmp_hosts 'disable'
option icmp_interval ‘1’
option timeout ‘3’
To Next Page
Loading...
Need help?
General