35: Event system
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 318 of 350
35.4 Supported targets
The table below describes the targets currently supported.
Event sent to syslog server.
Event sent via SNMP trap.
Command executed when event occurs.
Table 111: Targets currently supported
The attributes of a target vary significantly depending on its type.
35.5 Supported connection testers
The table below describes the methods to test a connection that are currently supported.
Checks if the interface used to reach the target is up.
Pings the target. And then assumes there is connectivity during a configurable amount of time.
Table 112: Event system - supported connection tester methods
35.6 Configuring the event system using the web interface
Configuring the event system using the web interface is not currently supported.
35.7 Configuring the event system using UCI
The event system configuration files are stored at /etc/config/va_eventd
The configuration is composed of a main section and as many forwardings, targets and
connection testers as required.
35.7.1 Va_eventd: main section
35.7.1.1 Main using UCI
root@VA_router:~# uci show va_eventd
va_eventd.main=va_eventd
va_eventd.main.enabled=yes
va_eventd.main.event_queue_file=/tmp/event_buffer
va_eventd.main.event_queue_size=128K
To Next Page
Loading...
Need help?
General