virtual access GW2024P-2 User Manual

22: Configuring a mobile connection
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 169 of 350
Web Field/UCI/Package Option
Description
Web:Bring up on boot
UCI: network.3G.auto
Opt: auto
Enables the interface to connect automatically on boot up or
reconnect automatically when disconnected.
Web: Monitor interface state
UCI: network.3G.monitored
Opt: monitored
Enabled if status of interface is presented on Monitoring platform.
0
Do not monitor interface
1
Monitor interface
Web: Enable IPv6 negotiation on the PPP
link
UCI: network.3G.ipv6
Opt: ipv6
Enables IPv6 routing on the interface.
0
Do not enable IPv6
1
Enable IPv6
Web: Modem int timeout
UCI: network.3G.maxwait
Opt: maxwait
Maximum amount of seconds to wait for the modem to become
ready.
20
seconds
Range
Web: Use default gateway
UCI: network.3G.defaultroute
Opt: defaultroute
Enables this interface as a default route
0
Do not use as a default route
1
Use as a default route
Web: Use gateway metric
UCI: network.3G.metric
Opt: metric
Uses the specified metric. Lower number metrics are used first
when route is up.
0
Range
Web: Use DNS servers advertised by peer
UCI: network.3G.peerdns
Opt: peerdns
If unchecked, the advertised DNS server addresses are ignored
0
Use static DNS
1
Use advertised DNS
Web: Use custom DNS servers
UCI: network.3G.dns
Opt: dns
Specify DNS server. Only available if Use DNS servers
advertised by peer is unselected. When multiple DNS servers
are required separate using space for UCI or option value.
Example:
uci set network.3G.dns=’1.1.1.1 2.2.2.2’
Web: LCP echo failure threshold
UCI: network.3G.keepalive
Opt: keepalive
Presume peer to be dead after given amount of LCP echo
failures, use 0 to ignore failures
This command is used in conjunction with the LCP echo interval.
The syntax is as follows: uci network.3G.keepalive=<echo failure
threshold> <echo interval>
Example:
uci set network.3G.keepalive=15 10
Web: LCP echo internal
UCI: network.3G.keepalive
Opt: keepalive
Send LCP echo requests at the given interval in seconds, only
effective in conjunction with failure
This command is used in conjunction with the LCP echo failure
threshold. The syntax is as follows: uci
network.3G.keepalive=<echo failure threshold> <echo interval>
Example:
uci set network.3G.keepalive=15 10
Web: Inactivity timeout
UCI: network.3G.demand
Opt: demand
Close inactive connection after the given amount of seconds, use
0 to persist connection.
0
Do not disconnect on inactivity
Range

virtual access GW2024P-2 Specifications

General

Brand	virtual access
Model	GW2024P-2
Category	Wireless Router
Language	English