virtual access GW2024P-2 User Manual

24: Configuring Multi-WAN
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 180 of 350
Web Field/UCI/Package Option
Description
Web: Enable
UCI: multiwan.config.enabled
Opt: enabled
Enables or disables Multi-WAN.
0
Disabled.
1
Enabled.
Web: Preempt
UCI: multiwan.config.preempt
Opt: preempt
Enables or disables pre-emption for Multi-WAN. If enabled the
router will keep trying to connect to a higher priority interface
depending on timer set by ifup_retry_sec
0
Disabled.
1
Enabled.
Web: Alternate Mode
UCI: multiwan.config.alt_mode
Opt: alt_mode
Enables or disables alternate mode for Multi-WAN. If enabled the
router will use an alternate interface after reboot.
0
Disabled.
1
Enabled.
Table 61: Information table for multi-WAN page
When you have enabled Multi-WAN, you can add the interfaces that will be managed by
Multi-WAN, for example 3G interfaces.
The name used for Multi-WAN must be identical, including upper and lowercases, to the
actual interface name defined in your network configuration. To check the names and
settings are correct, select Network - > Interfaces and view the Interfaces Overview
page.
In the WAN interfaces section, enter the name of the WAN interface to configure, and
then click Add. The new section for configuring specific parameters appears.

virtual access GW2024P-2 Specifications

General

Brand	virtual access
Model	GW2024P-2
Category	Wireless Router
Language	English