24: Configuring Multi-WAN
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 187 of 350
Available commands:
start Start the service
stop Stop the service
restart Restart the service
reload Reload configuration files (or restart if that fails)
enable Enable service autostart
disable Disable service autostart
When troubleshooting, make sure that the routing table is correct using
route –n.
Ensure all parameters in the multi-WAN package are correct. The name used for multi-
WAN interfaces must be identical, including upper and lowercases, to the interface name
defined in the network configuration.
To check the names and settings are correct, browse to Network - > interfaces (or
alternatively, run: cat/etc/config/network through CLI).
Enter the name of the WAN interface to configure, and then click Add. The new section
for configuring specific parameters will appear.
To Next Page
Loading...
Need help?
General