virtual access GW2024P-2 User Manual

28: Configuring SNMP
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 266 of 350
Web Field/UCI/Package Option
Description
System settings
Web: System Location
UCI: snmpd.system[0].sysLocation
Opt: sysLocation
Sets the system location, system contact or system name for the
agent. This information is reported in the ‘system’ group in the
mibII tree.
Web: System Contact
UCI: snmpd.system[0].sysContact
Opt: sysContact
Web: System Name
UCI: snmpd.system[0].sysName
Opt: sysName
Agent Settings
Web: Agent Address
UCI: snmpd.agent[0].agentaddress
Opt: agentaddress
Specifies the address(es) and port(s) on which the agent should
listen.
[(udp|tcp):]port[@address][,…]
Web: Enable Authentication Traps
UCI: snmpd.agent[0].authtrapenabled
Opt: authtrapenabled
Enables or disables SNMP authentication trap.
0
Disabled.
1
Enabled.
Note: this is the SNMP poll authentication trap to be set when
there is a community mismatch.
Web: Enable Link State Notification
UCI: snmpd.agent[0].link_updown_notify
Opt: link_updown_notify
Generates trap/info when interface goes up or down. When
enabled, the router sends a trap notification link up or down.
0
Disabled.
1
Enabled.
Table 90: Information table for system and agent settings
28.2.2 Com2Sec settings
To access Com2Sec settings, scroll down the SNMP Services page.
Use the COM2Sec section to map SNMP community names into an arbitrary security
name. Map community names into security names based on the community name and
the source subnet. Use the first source/community combination that matches the
incoming packet.
Figure 134: The COM2Sec settings

virtual access GW2024P-2 Specifications

General

Brand	virtual access
Model	GW2024P-2
Category	Wireless Router
Language	English