31: Configuring Terminal Server
_______________________________________________________________________________________________________
_____________________________________________________________________________________________________
© Virtual Access 2017
GW1000 Series User Manual
Issue: 1.9 Page 301 of 350
31.6.3 Terminal Server debug statistics
To see debug statistics about the terminal server, enter:
root@VA_router:~# tserv show debug all
TERMINAL 1, Dev: /dev/ttySC0
State: LISTENING
netRxBuf length=0 offset=0 hdrsz=0
ttyRxBuf length=0 offset=16 hdrsz=16
line_status_mask = 0x0 line_status = 0x0
RFC2217 negotiated=0
Tcp tx last error: 0
31.6.4 Terminal Server advanced debugging
To see advanced debug commands for the terminal server, enter:
root@VA_router:~# tserv
=== Termserv disgnostics. Command syntax: ===
tserv show stats - show statistics
tserv clear stats - clear statistics
tserv show serial - show serial interface status
tserv send serial0 <data>- send data to serial port 0
tserv start capture N, N=port number (0 to 3) - start capturing rx serial
data
tserv print capture N, N=port number (0 to 3) - print captured rx serial
data
tserv show serial txlog
-hex <Port> [length], Port=port cfg index (0 to 3),
length=length to show
tserv show serial rxlog
-hex <Port> [length], Port=port cfg index (0 to 3),
length=length to show
tserv show serial txlog
-asc <Port> [length], Port=port cfg index (0 to 3),
length=length to show
tserv show serial rxlog
-asc <Port> [length], Port=port cfg index (0 to 3),
length=length to show
tserv show debug - show debug info
tserv show userial stats - show USB serial card statistics
tserv clear userial stats - clear USB serial card statistics
tserv start userial rxlog - start USB serial card rx log
tserv show userial rxlog <offs> <length> - show USB serial card rx log
To Next Page
Loading...
Need help?
General