16
Visionix EyeRefract User Guide
16
Equipment and Installation
Lift the unit by its base (#2), not its heads or
headrest (#1)
Open the plastic bag, carefully lift the unit by its base, remove it from the bag, and place it
on a table.
Unit removed from bag, with foam pad (#1)
behind its heads
Slowly slide the polystyrene foam pad (#1 above) out from behind the heads of the unit.
Raise the flap of the near-vision target, and remove the polystyrene foam pad from
beneath it.
Polystyrene foam pad
under near-vision flap
To Next Page
Loading...
