300004969171/B Page 73 of 148
Annotating Frames
Using the keyboard, you can annotate saved frames and video loops.
1 Select a saved image or video loop to annotate by clicking on its name in the Case
Explorer.
2 Using the trackball on the control console, move your cursor to the image area you
wish to annotate.
3 Using the retractable keyboard, type the annotation.
4 Press Select (+) to place it where you want the annotation.
5 To edit an annotation, move the cursor over the annotation and press Select(+).
Edit the annotation and press Select again.
6 To reposition the annotation, press Select(+)and drag the annotation to another
place on the image. Press Select again.
7 To delete an annotation move the cursor over the annotation, press Select(+), and
backspace over it using the keyboard keys. You can also check the Delete tab (in
Measure mode) and move the scissors to the annotation with the trackball, then
press Select(+) to delete it.
Figure 39: Saved Frame with Annotation
Annotation
To Next Page
Loading...