VOLKTEK NSH-5509 MANAGED 8-PORT 10/100 + 1-PORT 100-FX SWITCH
2
Insert the RJ-45 side of the (8-pin RJ-45 to DB-9) cable into the RJ-45
console port on the Switch and the other end into the COM port of the
computer.
3 Configure the Hyper Terminal settings as mentioned in chapter 7.
For console port (8 pin RJ-45) pin assignment, please see Appendix A.
3.8 Connecting to computers or a LAN
You can use Ethernet cables to connect computers directly to the Switch ports. You can
also connect hubs/switches to the switch ports by Ethernet cables. You can use either
crossover or straight-through Ethernet cables to connect computers, hubs, or switches.
3.9 Attaching the power adapter
Connect the AC power cord to the POWER receptacle on the back of the Switch and
plug the other end of the power cord into a wall outlet or a power strip.
Check the front LED indicators with the description in the next chapter. If the LEDs light
up as described, the Switch’s hardware is working properly.
12
To Next Page
Loading...
General