VOLKTEK NSH-5509 MANAGED 8-PORT 10/100 + 1-PORT 100-FX SWITCH
8.17 Host Denial of Service
This page enables the user to DENY ACCESS to the Switch’s remote management
interfaces to ALL IP addresses EXCEPT the maximum of five addresses that can be
entered on this page.
Note: If ‘Save’ is activated while the ‘Protection’ field is enabled and all of the ‘IP
Address’ fields are left blank or are not enabled, the Switch’s remote management
interfaces will become deactivated until such an act is reversed by accessing the Switch
at this page or via the console port.
Start by selecting “Enable” in the “Protection” field. Then access the first “IP Address”
field and type in the desired IP address and then “Enable” the field. Remember to select
“Enable” here again and remember to “Apply” after the desired IP addresses have been
entered. A total of five IP addresses can be selected.
8.18 Port Abnormal Traffic Detection
45
To Next Page
Loading...
General