VOLKTEK NSH-5509 MANAGED 8-PORT 10/100 + 1-PORT 100-FX SWITCH
NSH-5009# show
abnormal
cable
hdos
email-alarm
frame
igmp
interface
ip
locked-mac
logins
loop
mac
mac-limit
mirror
qos
rate_control
rmon
rstp
snmp
static-mac
system-information
trunk
version
vlan
xpress
Show abnormal traffic detection configuration
Show cable test results
Show Host Denial-of-Service configuration
Show email configuration
Show switch frame
Show switch IGMP
Show port configuration
Show network configuration
Show Lock prevent unknown MAC configuration
Show login account information
Show loop detection configuration
Show switch MAC
Show MAC limit configuration
Show mirror configuration
Show QoS configuration
Show rate control configuration
Show RMON information
Show RSTP configuration
Show SNMP configuration
Show static unicast MAC configuration
Show system configuration
Show trunk configuration
Show system version
Show VLAN configuration
Show Xpress Ring configuration
9.3 System configurations
Type “configure terminal” in enable mode to access the configuration mode.
NSH-5009# configure terminal
NSH-5009(config)#
You can type in “?” or “help” followed by “Enter” key to display a full list of help
commands with explanations of their functions. For detail command lists, please
reference to appendix B.
9.3.1 Port configurations
Change the configuration mode to configure parameters of switch ports with the following
command:
NSH-5009(config)# interface port-channel <port-list>
For example, use this command to access port 1.
NSH-5009(config)# interface port-channel 1
NSH-5009(config-interface)#
50
To Next Page
Loading...
General