16
MAINTENANCE OF THE VOLVO PENTA
ELECTRONIC CONTROL SYSTEM
Check the mechanical cables and their fittings. See
page 18.
Check all electrical connections and lubricate all
contactors with a very thin layer of terminal grease,
Volvo Penta part no. 1161417-9.
Check the actuators by forcing out the moving part as
far as possible. Clean and apply a very thin layer of
water-resistant grease.
Check that the circuit breakers are in good condition.
Check that the batteries’ acid weight and voltage are
satisfactory and that the cables to the drive unit are not
damaged or otherwise in poor condition.
The maintenance work described above must be
carried out once every season or at least once a year.
System calibration is performed once a year, see page
8.
Protect the controls against sun and water when the
boat is not in use.
User Instructions
To Next Page
Loading...