4-54 BA 357-00 * 3.0 * 35700_04_Inbetriebnahme_03.fm
4 Putting into operation
Turn on the machine
1. Switch on the motor isolating switch
– see "Motor isolating switch" on page 4-22.
2. Insert the ignition key.
➥ In position 0 – no operating voltage.
3. Turn the ignition lock 18 to position "II" and wait.
➥ The battery charge condition and the operating hours are displayed.
➥ After the audible clicking of the safety devices of the travel drive
and the operating drive, the machine is ready for operation.
4. Release the parking brake.
– see chapter 5 “Parking brake” on page 5-6
5. Select the travel direction– see chapter 5 “Selecting a travel direction
and starting machine travel” on page 5-13.
➥ The machine is ready for travel operation.
To avoid wear-and-tear on the mechanical components, do not
immediately begin driving after starting up the machine!
► Wait at least 5 seconds.
The machine is equipped with an operator presence switch to protect the
operator. In this case:
• The machine can only be switched on if the operator has taken his
place in the operator seat.
To Next Page
Loading...
Need help?
General
