Sound Parameters – LFO Section
117 Waldorf microQ User´s Manual
LFO1 Spd.! Fade
056 ! +20
LFO1 Spd. – LFO 1 Speed 0...127
Determines the frequency of LFO 1. For the sake of completeness this parameter can be also found
here in the LFO Edit Menu. See "LFO 1 Speed" above.
Fade out 64…in 63
Controls the speed with which the LFO is faded in or out. With this parameter you can create slowly
rising or falling modulations that might create interest when routed to pitch or volume.
Please see the LFO Delay parameter on page 108 for further information.
LFO1 Sync!Startphase
Off ! free
LFO1 Sync On / Off
For the sake of completeness this parameter can be also found here in the LFO Edit Menu. See "Sync"
above.
Phase free, 000°…360°
Controls the initial phase of the LFO when a new note is started. Free means that the LFO isn’t
restarted on a new note but runs freely while other values set the LFO phase to the respective offset in
degrees.
LFO1 Clk !Keytrack
Off ! +000%
LFO1 Clk - LFO 1 Clocked Off / On
When LFO1 Clk is activated, the LFO is synced to the global Tempo of the microQ. The LFO Speed
setting for LFO 1 is changed to offer musically meaningful values.
Please read the section "The Tempo" on page 124 for further information.
Keytrack -200%...+196%
Determines how much the speed of the LFO depends on MIDI note number. The reference note for
Keytrack is E3, note number 64. For positive settings, the LFO speeds up on notes above the reference
note, for negative settings the LFO slows down when higher notes are played and vice versa. A setting
of +100% corresponds to a 1:1 scale, e.g. when the keyboard is played an octave higher, the LFO
speed is doubled.
LFO2 Shp.! Delay
Sine ! 000
LFO2 Shp. – LFO 2 Shape Sine / Triangle / Square / Saw / Random / S & H
Determines the shape of LFO 2. For the sake of completeness this parameter can be also found here
in the LFO Edit Menu. See "LFO 2 Shape" above.
To Next Page
Loading...
Need help?
General
