Basic Operation – Selecting Programs
29 Waldorf microQ User´s Manual
Multi Mode:
Inst:1 Multi:009
Venice Beach T
Drum Maps can be found in sound position 01 to 20 in Bank D. The microQ can only hold up
to 20 Drum Maps. Therefore higher storage positions aren’t available.
Fast Selection of Sound Banks in Single Mode
In Play mode the Banks can be changed quickly by using the endless knob right below the display.
Turning the knob clockwise raises the bank number, turning counterwise lowers it.
Selecting Programs with the Number Buttons (microQ Keyboard only)
At the microQ keyboard you can also use the program button section’s number buttons to select a
program. The following picture shows the program button section:
Program button section microQ Keyboard
To the left of the ten number buttons, you can see the Multi/Sound button. This button is used to set
the program type that is switched by the number buttons.
Entering a two-digit number will select the corresponding program within the current bank.
Here are three examples:
• Entering 01 will call up Program number 001 in the current bank.
• Entering 99 will call up Program number 099 in the current bank.
• Entering 00 will call up Program number 100 in the current bank.
☞ To select a Program with the Number Buttons :
1. Press the Multi/Sound button until the LED of the Program type you want to select lights
up.
2. Press one of the Instrument buttons Inst. 1…Inst. 4 to select an Instrument that holds the
Sound. The LED above the button lights up and the display content will change to show the
current Sound for this Instrument.
3. Enter a two-digit number with the number buttons.
4. The display shows the Program number in the top right corner and the name of the selected
Program.
Drum Maps are located at number 01 to 20 of bank D. You can´t select higher a program
number for this program type.
To Next Page
Loading...
Need help?
General
