Other Functions – Updating the System Software
143 Waldorf microQ User´s Manual
Updating System
Do not under any circumstances turn off the microQ while this step is in progress.
A complete loss of data may occur and it will be impossible for you to make your machine
work again!
7. Wait until the operation is completed. If updating was successful, the microQ will perform
a system reset and start up.
If an error occurs in the process of updating, the microQ displays an error message, e.g.:
Checksum Error
If this happens, try updating again. In some cases it can be helpful to adjust the sequencer tempo
before playing the file so that the data events are sent more slowly.
If this message appears:
SysEx Timeout
the file wasn’t transmitted completely to the microQ or played back too slowly. Try to download the
file from the Internet again.
New functions in future OS will be documented in PDF files which are available on our
website (http://www.waldorf-music.com) or at our ftp-server ( ftp://ftp.waldorf-
gmbh.de/microq ).
Erasing internal data flash memory (not for microQ lite)
Holding down the Global + Inst.3 buttons during power-up erases all data flash memory. All
programs will be set to initial settings.
We recommended to use this function before dumping a complete new sound set into your
microQ.
몇 Attention – By using this function you will lose all your stored programs. Please be sure
backup your programs before.
To Next Page
Loading...
Need help?
General
