890557_d•en•01.07.2014
We reserve the right to carry out improvements
30
Wisotronic 1-channel
Operating instructions
Brightness at standby
If the Wisotronic is not operated for longer than 3 minutes, the display is set
to a freely adjustable brightness value (e.g. darkened).
Set this [Brightness at standby] in the first menu line:
Press the touchwheel; the value on the right becomes editable and the dis-
play is dimmed to the indicated value.
By turning the touchwheel to the right or left, the bar moves and the bright-
ness is increased or reduced.
You will see the effects by the change of the display. If you select a setting
below 10% (OFF is displayed), the display will go completely dark after 3
minutes. The brightness is increased by turning the touchwheel in a clock-
wise direction.
The [Stand.] function button sets the factory setting of 20%.
Brightness at operation
Set the [Brightness at operation] in the same manner in the next menu
line.
The brightness during operation can be reduced to a minimum level of 10%.
Darkening the display completely during operation is counterproductive.
The factory setting ([Stand.] function button) is 30%.
Button tone
You change the behaviour of the function buttons in the line [Button tone].
Turning the touchwheel sets or deletes the checkmark at the right, thereby
activating or deactivating the actuation tone of the function buttons.
The [Stand.] function button sets the factory setting.
Additional functions
The other functions in this menu are described in detail in
Chapter 7.5.2 on page 87.
Pushing the function button [Back] returns you to the menu [System].
Getting started
To Next Page
Loading...
