WAREMA Wisotronic - Button Tone; Standbyduration; Display Behaviour of Wisotronic

890557_d•en•01.07.2014
We reserve the right to carry out improvements
88
Wisotronic 1-channel
Operating instructions
7.5.2.3 Button tone
You change the behaviour of the function buttons in the line [Button tone].
 Turning the touchwheel sets or deletes the checkmark at the right, thereby
activating or deactivating the actuation tone of the function buttons.
The [Stand.] function button sets the factory setting.
7.5.2.4 Standbyduration
After 15 minutes without manual operation in the operator mode, the display
changes to standby mode.
 The duration of standby mode is selected in the [Standby duration] menu
item. The time can be set in the range of 1 to 240 min.
7.5.2.5 Display behaviour of
Wisotronic
[Brightness at operation] (10...100%) [Brightness at standby] (OFF, 10...100%) [Standby mode] [Standby duration] (1...240min) —
0 3 15 16...255

Minutes
Last operating pro-
cedure
Dim to standby
brightness
Change to standby
mode, display Start
menu
Activate screen sav-
er, display time
Fig. 16 Display behaviour
System settings