890557_d•en•01.07.2014
We reserve the right to carry out improvements
62
Wisotronic 1-channel
Operating instructions
7.2.4.2 Off delay
In this menu line, you can set the delay time after which the comfort functions
and the manual operation are released again after the end of the measured
precipitation. This delay time helps to "quiet" the motion behaviour of your
sun shading, thereby increasing the level of comfort. For example, move
commands are not executed every time rainfall stops briefly. The setting
range is 0-99 minutes.
Turn the touchwheel to set the value “Off delay”.
The value [0 Min.] deactivates the delay, the function button [Stand.] sets
the value for the product-specific factory setting.
7.2.4.3 Position PRECIPITATION
The “Position PRECIPITATION” value specifies the position to which the
sun shading product is to move during precipitation. The setting range is
0...100%; a value of 0% corresponds to the upper limit position and a value of
100% to the lower limit position.
Turn the touchwheel to set the value “Position precipitation”.
The [---] function button sets the value to [---] (Position unchanged); the
[Stand.]function button sets the “Position precipitation” value to the factory
setting.
7.2.4.4 Slat angle PRECIPITATION
This setting is only useful when you have chosen a slat product (external or
internal venetian blinds). If you have connected a slat product (such as an
external venetian blind), you can specify how the slats are to be set after
movement to the "PRECIPITATION" position is completed. This is especially
useful if you prefer a specific setting. In addition, you must no longer tilt the
slats manually after automatic movement. The precipitation monitor tilts the
slats automatically if programmed accordingly.
Turn the touchwheel to set the value “Slat angle PRECIPITATION”.
The function button [---] leaves the slat angle unchanged; function button
[Stand.] sets the product-specific factory setting.
7.2.4.5 Active during leave?
In this menu line, you can activate or deactivate the precipitation monitor dur-
ing your leave.
Set or delete the checkmark in the line [Active during leave?] to activate
or deactivate the precipitation monitor during your leave.
The [Stand.] function button sets the factory setting.
Precipitation monitor
To Next Page
Loading...
