890557_d•en•01.07.2014
We reserve the right to carry out improvements
34
Wisotronic 1-channel
Operating instructions
7.1.2 Brightness
The “Brightness” value specifies the brightness at which the sun shading
product is to be lowered by the sun control. The setting range is 3...100 klx.
Adjust the value for the brightness by turning the touchwheel (the bar at the
right moves accordingly).
The [Stand.] function button sets the value to the factory setting.
OTEN At the same time, the limit values SUN, CLEAR (e.g. moving to
a medium position or tilting up of the slats) and CLOUD (e.g.
raising the sun shading) are automatically adjusted.
7.1.3 Movements
A delay time can be assigned to the sun control to prevent the sun shading
product from being lowered immediately as soon as the brightness changes.
This quiets the motion behaviour of the sun shading product, thereby increas-
ing the level of comfort. When the limit values are reached or exceeded for
the duration of this delay time, a command is triggered and the sun shading
product is lowered. The setting range is 0...99 minutes.
Adjust the value for the (delay) of the movements by turning the touchwheel
(the bar graphic at the right changes accordingly).
The value 0 min. deactivates the delay, the [Stand.] function button sets the
value to the factory setting.
OTEN At the same time, the delay times CLEAR (e.g. moving to a me-
dium position or tilting of the slats) and CLOUD (e.g. raising the
sun shading) are automatically adjusted.
7.1.4 Dawn/dusk control
ON/OFF
Set or delete the checkmark in the [Dawn/dusk control ON/OFF] line to acti-
vate or deactivate the dawn/dusk control.
The [Stand.] function button switches the dawn/dusk control on or off, de-
pending on the channel type.
OTEN The delay time for a move command is fixed for the dawn/dusk
control and cannot be changed. It is 5 minutes.
7.1.5 Dawn/dusk
The “Dawn/dusk” value specifies at which brightness the sun shading prod-
uct should be lowered or raised by the dawn/dusk control. The setting range
is 0...500 lx.
Set the “Dawn/dusk” value by turning the touchwheel.
The [Stand.] function button sets the value to the factory setting.
OTEN At the same time, the limit value for raising the sun hading
product is set to the same value.
Basic functions
To Next Page
Loading...
