WAREMA Wisotronic - 7.2.2.1 Dawn;dusk control ON;OFF; 7.2.2.2 Limit value DAWN; 7.2.2.3 Position DAWN

890557_d•en•01.07.2014 We reserve the right to carry out improvements
45
7.2.2.1 Dawn/dusk control ON/OFF
In this menu line you set whether or not to activate the dawn/dusk control for
this channel.
 Set or delete the checkmark in the [Dawn/dusk control ON/OFF] line to acti-
vate or deactivate the dawn/dusk control.
The function button [Stand.] selects the factory setting.
7.2.2.2 Limit value DAWN
The "DAWN" value specifies the brightness at which a sun shading product is
to be moved in the morning. The setting range is 0...500 lx.
 Turn the touchwheel to set the limit value "DAWN".
The function button [---] deactivates the evaluation; the function button
[Stand.] sets the limit value "DAWN" to the product-specific factory setting.
7.2.2.3 Position DAWN
The "DAWN" position value specifies the position to which the sun shading
product is to move at dawn. The setting range is 0-100%; a value of 0% cor-
responds to the upper limit position and a value of 100% to the lower limit
position.
 To set the value "Position DAWN", turn the touchwheel (the value increases
or reduces depending on the direction of rotation).
The function button [---] leaves the position unchanged; the function button
[Stand.] sets the value for the “Position DAWN” to the product-specific fac-
tory setting.
7.2.2.4 Slat angle DAWN
This setting is only useful when you have chosen a slat product (external or
internal venetian blinds). If you have connected a slat product (such as a
venetian blind), you can specify how the slats are to be set after lowering to
the "WARM" position is completed. This is especially useful if you prefer a
specific setting. In addition, you do not have to tilt the slats up after automatic
movement. The automatic dawn/dusk mode tilts the slats automatically if pro-
grammed accordingly.
 Turn the touchwheel to set the value "Slat angle DAWN".
The function button [---] leaves the slat angle unchanged; the function but-
ton [Stand.] sets the value for the “Slat angle DAWN” to the product-specific
factory setting.
Dawn/Dusk control