WAREMA Wisotronic - 7.2.1.6 Limit value CLEAR

890557_d•en•01.07.2014 We reserve the right to carry out improvements
39
The following drawing is meant to explain the setting of the slat angle:
Positive value:
Slats are tilted outward
Negative value: Slats are tilted inward
Setting 0°: The slats remain in a horizontal position
+80
0
-80
Outside Inside
Fig. 11 Slat angle for external and internal venetian blinds
The setting range in ° depends on the first product set for this channel.
 Turn the touchwheel to set the "SUN" limit value.
The [Stand.] function button sets the value to the factory setting.
7.2.1.6 Limit value CLEAR
This limit value specifies the brightness at which a sun shading product is to
move to a medium position and, in the case of external or internal venetian
blinds, the slats are to be tilted up, for example, to allow more light to enter
the room during a covered but otherwise bright sky. The setting range is
2...100 klx.
NOTE The limit value "CLEAR" is only assessed when the sun shading product was
first lowered automatically via "SUN" and not if the previous condition was
"CLOUD"!
 Turn the touchwheel to set the "CLEAR" limit value.
The [Stand.] function button sets the limit "CLEAR" to the factory setting).
The function wheel [---] deactivates the limit value.
Sun control