890557_d•en•01.07.2014 We reserve the right to carry out improvements
93
7.5.6 Wind test
This function is actually a repetitive check of the wind sensors connected
to the Wisotronic. A description can be found in the installation instructions,
Chapter 8.1.5.
7.5.7 Restore settings
This menu line serves to restore the settings made by the specialist dealer
during commissioning.
NOTE To be able for you to restore the service settings, it is necessary that the spe-
cialist dealer saves the settings made during commissioning.
CAUTION
When you restore the service settings, your individual settings are lost.
Press the [Sett.] function button in the main menu and then go to the
[System] > [Restore settings] menu.
The following questions appears on the left in the menu line:
[From service setting?]
Pressing on the [YES] button or on the touchwheel adopts the service set-
tings. [Please wait...] appears briefly on the right for several seconds and
then disappears. The service settings have been restored.
NOTE If the special dealer did not save the settings, the following message appears
on the right in the menu line: [Service settings not stored.]
After the service settings are restored, the [Load data in actuator] menu
appears.
Press the touchwheel to finish adoption of the service settings.
After the loading process is completed, the [System] menu appears again.
Start menu
Main menu
Settings
System
Restore settings
System settings
To Next Page
Loading...
