WAREMA Wisotronic - Auto Control DUSK; Active During Leave; Active During Absence; Measured Value Dawn;Dusk

890557_d•en•01.07.2014 We reserve the right to carry out improvements
47
7.2.2.9 Auto control DUSK
All automatic comfort features except for the dawn/dusk control and the tim-
er switch can be disabled and enabled at any time. For this purpose, select
[Disable] or [Enable] under "Auto control DUSK".
NOTE If you select [unchanged] here, the release setting of the last switching time
of the dawn/dusk control or the timer applies. If the automatic comfort fea-
tures were disabled before, the "Position DUSK" and "Slat angle DUSK" move
commands (see above) are not carried out (otherwise always!).
 To set whether the automatic comfort features should be enabled, disabled
or left unchanged at the value "Auto control DUSK", turn the touchwheel (the
current setting is displayed on the left in the menu line).
The [---] function button leaves the automatic features unchanged; the
[Stand.] function button sets the product-specific factory setting.
7.2.2.10 Active during leave?
In this menu line, you can activate or switch off the dawn/dusk control during
your leave.
 Set or delete the checkmark in the line [Active during leave?] to activate
or deactivate the dawn/dusk control during your leave.
The function button [---] deletes the checkmark, the function button
[Stand.] sets it (factory setting).
7.2.2.11 Active during absence?
In this menu line, you can activate or deactivate the dawn/dusk control dur-
ing your absence.
 Set or delete the checkmark in the line [Active during absence?] to acti-
vate or deactivate the dawn/dusk control during your absence.
The [Stand.] function button sets the factory setting.
7.2.2.12 Measured value dawn/dusk
The line "Measured value dawn/dusk" indicates the outdoor brightness cur-
rently measured and is for information only.
7.2.2.13 Automatic status
The "State control" line shows the current status of the control mode and is
for informational purposes only.
7.2.2.14 Auto control status
The "State auto control" line shows the current status of the automatic control
and is for informational purposes only.
Dawn/Dusk control