890557_d•en•01.07.2014
We reserve the right to carry out improvements
46
Wisotronic 1-channel
Operating instructions
7.2.2.5 Auto control DAWN
All automatic comfort features except for the dawn/dusk control and the tim-
er switch can be disabled and enabled at any time. For this purpose, select
[Disable] or [Enable] under "Auto control DAWN".
NOTE If you select [unchanged] here, the release setting of the last switching time
of the dawn/dusk control or the timer applies. If the automatic comfort fea-
tures were disabled before, the move commands "Position DAWN" and "Slat
angle DAWN" (see above) are carried out (otherwise always!).
To set whether the automatic comfort features should be enabled, disabled
or left unchanged at the value "Auto control DAWN", turn the touchwheel
(the current setting is shown on the left in the menu line).
The function button [---] leaves the automatic release unchanged; function
button [Stand.] sets the product-specific factory setting.
7.2.2.6 Limit value DUSK
The "DUSK" value specifies the brightness at which a sun shading product is
to be moved to the "DUSK" position. The setting range is 0...500 lx.
Turn the touchwheel to set the value “Slat angle DUSK”.
The function button [---] deactivates assessment; the function button
[Stand.] sets the limit value "DUSK" to the product-specific factory setting.
7.2.2.7 Position DUSK
The "Position DUSK" value specifies the position to which the sun shading
product is to move at dusk. The setting range is 0-100%; a value of 0% cor-
responds to the upper limit position and a value of 100% to the lower limit
position.
Turn the touchwheel to set the value "Position DUSK".
The function button [---] leaves the position unchanged; the function button
[Stand.] sets the value for the “Position DUSK” to the product-specific fac-
tory setting.
7.2.2.8 Slat angle DUSK
This setting is only useful if you have chosen a slat product (external or inter-
nal venetian blinds) as the channel type. If you have connected a slat prod-
uct (such as a venetian blind), you can specify how the slats are to be set
after the movement to the "DUSK" position has been completed. This is es-
pecially useful if you prefer a specific setting. In addition, you must no longer
tilt the slats manually after automatic movement. The dawn/dusk control tilts
the slats automatically if programmed accordingly. The factory setting for the
slat position with automatic operation is +80°.
Turn the touchwheel to set the value “Slat angle DUSK”.
The function button [---] leaves the slat angle unchanged; the function but-
ton [Stand.] sets the value for the “Slat angle DUSK” to the product-specific
factory setting.
Dawn/Dusk control
To Next Page
Loading...
