上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
5 / 97
– : It is used to exit the current interface or dialog box, or return
to the previous interface.
– : It is used to clear the workpiece coordinates of X-axis and Y-
axis at the same time.
– :
• General NK105 with four axes: It is used to clear the workpiece
coordinate of Z-axis or A-axis.
• General NK105 with double Z axes: It is used to clear the
workpiece coordinate of Z1-axis.
– : It is an auxiliary key or used to switch between Jog and Step
mode in the main interface.
– : It is used to increase the feedrate override.
– : It is used to decrease the feedrate override.
– : It is used to move X-axis / Y-axis to the workpiece origin or
input the figure 0.
– : It is used to move X-axis in the negative direction or input the
figure 4.
To Next Page
Loading...
