上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
43 / 97
3. To enter the operation interface, select 3. Operations by pressing /
, and press .
4. To start machining from the adjacent point of spindle, select 9. Nearby Process
by pressing / , and press .
6 Parameter Maintenance
6.1 Back up Parameters
This operation is used to back up parameters as a file.
To back up parameters, do the following:
1. To enter the menu interface, press .
2. To enter the interface of parameter maintenance, select 6. Param Upkeep by
pressing / , and press .
3. To back up parameters, select 1. Backup Params by pressing /
, and press .
The prompt Successfully saved. appears.
If the prompt Failed to save. appears, try again or contact us.
To Next Page
Loading...
