上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
39 / 97
3. To parse machining ranges, select 4. Machining Info by pressing /
, and press :
5.4 Set the Stop Position
This operation is used to set the stop position for the spindle after machining.
To set the stop position, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
3. To enter the interface for setting the stop position, select 5. Park MCS Site by
pressing / , and press .
To Next Page
Loading...
