上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
35 / 97
4.8.5 Handle the Hard Limit
The system regularly checks the hard limit, a limit switch (travel switch). And when
the hard limit is triggered, the prompt Limit. Exit manually. appears.
To handle the hard limit, do the following:
1. To release the limit, press . The system automatically enters Jog mode,
and character Limit Rls shows in the lower right corner of main interface:
2. Move the machine tool away from the limit position. Character Limit Rls turns
to Jog.
5 Common Operations
Through this section, you can quick know the common operations of NK105.
5.1 Set the Machining Wizard
NK105 supports to machine the rectangular milling face or circle milling face.
To set the machining wizard, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
To Next Page
Loading...
