上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
33 / 97
4.8.2 Adjust the Spindle Speed
The spindle speed has 11 gears with the minimum unit 0.1. This operation is used to
adjust the spindle speed within 0.5S ~ 1.5S.
To adjust the spindle speed, press + / + .
4.8.3 Execute the Fine Adjustment
This operation is used to manually make the fine adjustment in running status or
pause status, if the machining is incomplete.
If you temporarily add compensations during machining, it takes effect only in Auto
mode.
During executing the fine adjustment, the system automatically enters Step mode.
Every time you press an axis button, the corresponding axis moves a step size.
Before executing the fine adjustment, do one of the following:
• To enter the running status, start machining.
• To enter the pause status after starting machining, press .
To execute the fine adjustment, do the following:
1. To enter the interface of fine adjustment, press + .
2. To set the step size, press + .
Step size: 0.01, 0.02, 0.05, 0.10, 0.20, 0.50, 1.00.
3. To make the fine adjustment for the corresponding axis, press /
/ / / / / / .
To Next Page
Loading...
