上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
23 / 97
3.9 Set the Spindle
This operation is used to set parameters Spindle NO / OFF Delay, Spindle Speed
and Maximum Spindle Speed, so as to control the spindle motor.
To set the spindle, do the following:
1. To enter the menu interface, press .
2. To enter the interface of manufacturer parameters, select 5. Mfr Param by
pressing / , and press .
3. To check the spindle parameters, select 8. Spindle Set by pressing /
, and press .
About parameter details, see Spindle.
4. To set the spindle parameters, select 1. ON / OFF Delay / 2. Spindle Speed / 3.
Max Spdl Speed by pressing / , input the value and press
.The prompt The parameters are modified. Restart? appears.
5. To validate the setting, press . NK105 automatically restarts.
To Next Page
Loading...
