上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
20 / 97
3.6 Adjust the Axis Direction
This operation is used to check if the positive direction of each axis is the same with
that stipulated by Right Hand Rule, and adjust it if not, so as to avoid damage to the
machine tool due to incorrect direction.
Taking X-axis as an example, to adjust the axis direction, do the following:
1. To enter the menu interface, press .
2. To enter the interface of manufacturer parameters, select 5. Mfr Param by
pressing / , and press .
3. To check the X-axis direction, select 2. Axis Output Dir by pressing /
, and press :
4. According to Right Hand Rule, judge the positive direction of X-axis.
5. To check if the positive direction of X-axis is the same with the direction
stipulated by Right Hand Rule, move X-axis by pressing / ,
and observe its moving direction：
– Two directions are the same: The value of parameter Axis Output
Direction is correct.
– Two directions are opposite: Modify the value of parameter Axis Output
Direction to the opposite value.
To Next Page
Loading...
