上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
27 / 97
You can also do one of the following for the selected program file in the host or a
USB flash disk:
• To delete the program file, press .
• To copy the program file to a USB flash disk or the host, press .
4.3 Select a WCS
In programming, programmers select a certain given point on workpiece as origin
(called program origin or workpiece origin) to establish a new WCS.
In general N105 with four axes, the figures (1 ~ 6) before each axis in the main
interface indicate the corresponding WCS (G54 ~ G59).
To select a WCS, do the following:
1. To enter the menu interface, press .
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
3. To enter the interface for selecting a WCS, select 6. Select WCS by pressing
/ , and press :
To Next Page
Loading...
