WEIHONG NK105G3 - General NK105 with Double Z Axes

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
29 / 97
2. To execute tool calibration, press + . After calibration,
the coordinate of Z-axis is the workpiece origin of Z-axis.
3. To specify the workpiece origin of A-axis, manually move A-axis to the target
position and press .
4.4.2 General NK105 with Double Z Axes
To define the workpiece origin, do the following:
1. To specify the workpiece origins of X-axis and Y-axis, do one of the following:
– To clear the coordinates of X-axis and Y-axis at the same time, manually
move X-axis and Y-axis to the target position and press .
– To separately clear the coordinate of X-axis or Y-axis, do one of the
following:
• To clear the coordinate of X-axis, manually move X-axis to the
target position and press + .
• To clear the coordinate of Y-axis, manually move Y-axis to the
target position and press + .
2. To specify the workpiece origin of Z1-axis, manually move Z1-axis to the target
position and press .
3. To specify the workpiece origin of Z2-axis, manually move Z2-axis to the target
position and press + .