上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
42 / 97
2. To enter the operation interface, select 3. Operations by pressing /
, and press .
3. To check the list of workpiece origins, select 8. Origin List by pressing
/ , and press .
4. Select the target coordinates by pressing / , and press
→ .
After saving the workpiece origin, according to your need, do one of the following:
• To load the saved workpiece origin, select the target coordinates by pressing
/ , and press → .
• To delete the saved workpiece origin, select the target coordinates by pressing
/ , and press → .
5.7 Select an Adjacent Point for Machining
This operation is used to select the machining point that is the closest to the current
spindle position, and then start machining from this point.
To select an adjacent point for machining, do the following:
1. Manually move the spindle to an adjacent point for machining.
2. To enter the menu interface, press .
To Next Page
Loading...
