上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
34 / 97
4. To return to the main interface, press .
5. According to the operation status, do one of the following:
– Running status: Keep machining.
– Pause status: To continue machining from the pause position, press
.
If machining normally ends or if you start machining after pausing it, the fine
adjustment is always valid.
If one of the following occurs, the file adjustment is invalid:
• If the system enters the idle status.
• If you execute breakpoint resume or start machining whether or not the action
that you power on after powering off occurs, after machining stops.
• If you execute returning to the machine origin again and then start machining,
after E-stop or limit alarm occurs.
4.8.4 Handle the Soft Limit
If an axis exceeds the upper / lower limit of workbench travel during machining, the
soft limit will be triggered.
To handle the soft limit, do the following:
1. To exit the alarm dialog box and return to the main interface, press /
.
2. To release the soft limit, manually move the limit axis in the reverse direction.
After releasing the soft limit, the system forbids the limit axis to move towards
the limit direction.
To Next Page
Loading...
