WEIHONG NK105G3 - Page 4

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
8.2 Check Buttons ..................................................................................................................................... 57
8.3 Check Input Ports ............................................................................................................................. 58
8.4 Check Output Ports.......................................................................................................................... 59
8.5 Check LED Lights .............................................................................................................................. 60
9 System Parameters ........................................................................................................................................ 61
9.1 Operator Parameters...................................................................................................................... 61
9.1.1 Machining Wizard.............................................................................................................. 61
9.1.2 Velocity..................................................................................................................................... 62
9.1.3 Returning to the Machine Origin before Machining ..................................... 62
9.1.4 Z Position at Pause ............................................................................................................ 63
9.1.5 Offset.......................................................................................................................................... 64
9.1.6 Cycle Machining .................................................................................................................. 64
9.1.7 Command ................................................................................................................................ 65
9.1.8 Stopping the Spindle ........................................................................................................ 66
9.1.9 Override ................................................................................................................................... 66
9.1.10 File............................................................................................................................................ 67
9.1.11 Tool Change ........................................................................................................................ 70
9.1.12 Red Light .............................................................................................................................. 71
9.1.13 Calibration Height .......................................................................................................... 71
9.1.14 Tool Compensation ........................................................................................................ 71
9.2 Manufacturer Parameters ........................................................................................................... 72
9.2.1 Velocity..................................................................................................................................... 72
9.2.2 Axis Output Direction ...................................................................................................... 77
9.2.3 Pulse Equivalence .............................................................................................................. 77
9.2.4 Workbench Travel............................................................................................................. 77
9.2.5 Tool Change Travel ........................................................................................................... 78
9.2.6 Travel Limit ........................................................................................................................... 78