6.10.3.2 Maintenance settings
For the available maintenance settings in ADJUST refer to Table 6-52 - Maintenance settings.
Tab 6-52 Maintenance settings
Item Parameter Function
001 Crank Angle (Crank angle
offset, engine TDC offset)
For crank angle settings and checks after mainte-
nance, or when the crank angle sensor unit is re-
placed.
For the input of crank angle differences (mean values)
and to do checks of the measured values.
002 Exv. closing offset (Exhaust
valve closing offset)
Cylinder pressure fine tuning in service: Lets you ad-
just the compression pressure.
003 Inj. begin offset (Injection
begin offset)
Cylinder pressure fine tuning in service: Lets you ad-
just the compression pressure.
004 Inj. correction factor (Injec-
tion correction factor)
The injected fuel quantity for each cylinder can be in-
dependently decreased to 80%.
X92DF
AA00-0000-00AAB-043L-A
Operation Manual User parameters and maintenance settings for WECS-9520
Winterthur Gas & Diesel Ltd.
- 418 - Issue 002 2020-08
To Next Page
Loading...
