PROCEDURE
1 To change-over from liquid fuel to gas, do as follows:
1.1 Make sure that the engine operates with MDO.
1.2 On the related control panel start the gas mode request.
NOTE: The ECS makes a test, if gas mode is available. Then the ECS sends
a signal to the gas pressure control system. This system automatically
starts the transfer preparation. When this transfer procedure is
finished, the ECS slowly changes to gas mode.
2 To change-over from gas to liquid fuel, do as follows:
2.1 On the related control panel start the diesel mode request.
NOTE: The ECS quickly changes from gas to MDO operation.
CLOSE UP
• None
X92DF
AA00-0000-00AAA-131J-A
Operation Manual Change-over to and from gas
Winterthur Gas & Diesel Ltd.
- 469 - Issue 002 2020-08
To Next Page
Loading...
