WARNING
Injury Hazard: Make sure that no personnel are near the flywheel or the engine, before
you operate the turning gear.
7 Operate the turning gear until the cam (006, Figure 10-7) is at the highest position.
8 Install the roller lifting tool (002) with the mark (001) points down.
9 Turn the roller lifting tool (002) 180° until the mark (001) points up.
NOTE: This gives a clearance X and thus the cam (006) cannot move the roller (007).
10 Install the claw (004) with the screw (003) to lock the roller lifting tool (002).
11 Install the cover to the supply unit (005).
CLOSE UP
• None
X92DF
AA00-5556-00AAA-510B-A
Operation Manual Disconnect the fuel pump
Winterthur Gas & Diesel Ltd.
- 556 - Issue 002 2020-08
To Next Page
Loading...
