Wisi Chameleon - Page 48

©WISI Communications 2015, Subject to technical changes and misprints
48
www.
www.wisi.de
Output / PSI/SI tables settings
Expanding the PSI/SI tables entry by clicking the leading
lists the PSI/SI tables. For each table or sub-table
there is a pop-up menu allowing you to Edit or Reset.
 Edit will allow you to Enable/Disable the PSI/SI
table, and configure the table repetition rate
 Reset will reset the settings to the default
values
Output / PSI/SI descriptors
For the PSI/SI tables that contain descriptors, you can
block incoming descriptors and create new descriptors.
The PSI/SI tables settings, and the PSI/SI descriptor
settings are generally intended for advanced settings,
and will be covered in §10.4.2.
Output / Service settings
The Service settings can be accessed by selecting Edit in
the pop up menu for a service, or by clicking the in
front of a service menu line.
For each service you can set:
 Service name
 Service Provider name
 SID (Service ID)
 LCN (Logical Channel Number)
 HD LCN (only for HD LCN for France)
 PMT PID
 PCR PID
 Service type
 Running status
The pop-up in the header of Service level allows you to
create a new service. A created service contains no
streams, and streams has to be added manually, see
§10.4.2 Advanced settings.