The pop-up for a service allows you to edit the service settings, see above. The
Revert changes will reset all service settings to the original values. Remove will
remove this service from the output. Simulcrypt allows you to Connect to /
Disconnect from SCG. Scrambling is described in §11. The Character encoding
menu allows you select the encoding standard for the service names and for the
provider names, see §10.4.3.
Output / Service / Streams settings
For each service in an output (TS), you
can edit the settings for the streams
(PIDs) in the service. Streams settings can
be accessed by selecting Edit in the pop
up menu for a stream, or by expanding
the stream menu and clicking the in
front of Settings.
Stream type (in HEX), and output PID can
be edited. A textual description of the
stream type will be indicated in a pop-up when entering a (HEX) stream type, if the stream type is according to the
DVB specification.
The pop-up at stream level allows you to edit the Out PID value, and block (or unblock) the
stream in the output TS. You can also select to scramble the stream. Scrambling is
described in §11.
To Next Page
Loading...
