Wolf COB-2 - Finishing Commissioning Steps

Commissioning
56 | WOLF GmbH 3066501_201910
► Find and x the leak.
► Measure the CO
2
level again.
CO
2
level remains below 0.2%, no leak in the ue system:
► End emissions test mode
✔ The heat generator shuts down.
► Close the test ports. When doing so, ensure the caps are seated rmly!
6.9 Conguringtheheatgenerator
Standard settings for heat generator on the control module.
► Set parameters (7.1 Parameter list).
6.10 Finishing the commissioning process
► Document values in “System and operator's log”.
► Complete commissioning report (12.1 Commissioning report).