General Setup
Xerox
®
B215 Multifunction Printer
User Guide
61
Date and Time Settings
Use the Date and Time feature to set or view the printer date, time, and time zone. These settings
affect the date and time stamp that appears on various printed documents and reports.
1. In Xerox
®
CentreWare
®
Internet Services, click Properties General Setup.
2. Click Date and Time.
3. For Time Zone, from the list or from the world map, select your time zone.
4. To allow the printer to update the time to reflect Daylight Saving Time automatically, select
Automatically adjust clock for daylight saving changes.
5. Select a date format, then select the Day, Month, and Year.
6. Select a time format, then type the Hours and Minutes. Select AM or PM.
7. Click Apply.
Power Management Settings
The amount of electricity the printer consumes depends on the way it is used. This device is designed
and configured to enable you to reduce your electricity usage.
Power Saver modes are enabled on your device by default to reduce energy consumption. If the printer
is not used for a specified period, it transitions to Low Power mode, then to Very Low Power mode. In
these modes, to enable reduced-power consumption, only essential functions remain active.
Note: Changing the default Power Saver activation times can result in an overall higher energy
consumption of the printer. Before you switch off Power Saver modes or set a longer activation
times, consider the increase in printer power consumption.
You can also enable the printer to power off automatically, either after a specific amount of time, or
when no activity is detected by the printer.
Note: The Auto Power Off feature is not enabled at the factory due to network activity, it is
provided as an option and can be configured at any time. For instructions, refer to Configuring
Auto Power Off.
Configuring the Power Saver Mode Settings
1. In Xerox
®
CentreWare
®
Internet Services, click Properties General Setup.
2. Click Power Management.
3. Select the Power Saver Mode 1 and Power Save Mode 2 settings required:
• Power Saver Mode 1 Timer: Specify the time the printer remains idle before it goes from
ready mode to Low Power Save mode.
• Power Saver Mode 2 Timer: Specify how long the printer remains in Low Power Save mode
before it goes into Very Low Power Save mode.
Note: The sum of the two timers cannot exceed 119 minutes.
4. Click Apply.
5. Click OK.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
