General Procedures and Information
6-56 04/08 Phaser 3100 MFP
Before you start, position the Soft-switch 1 bit n°8 to 1.
CAUTION
Undocumented functions are reserved. Do not try and use functions that are not documented in
this section, this may lead to the permanent loss of data.
• Printing all parameters (including installation and technical parameters):
• Switching to forced standby mode regardless of the clock:
• Switching to software download via a computer link:
• Save the directory and parameters on I2C card:
CAUTION
All data present on the i2c card prior to the operation will be lost after operation and replaced by
directory and parameters from the machine
• Restore the directory and parameters from I2C card:
CAUTION
All directory contacts and parameters stored in the machine prior to the operation will be lost after
operation and replaced by those from the i2c card.
• Launching scanner calibration:
• Displaying miniboot version:
• Displaying the state of the applications, traffic and drivers:
To Next Page
Loading...
