Xerox WorkCentre 4150

January 2016
2-62
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
08-700
Status Indicator RAPs
08-700 Out Bin Full RAP
08-700 The machine has detected that the exit tray is full.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
NOTE: The main PWB has test points. The location of the test points is shown on the following
PJ location illustrations:
• 4150 Main PWB.
• 4250/4260 Main PWB.
• 4265 Main PWB.
Refer to:
• (4150) Wiring Diagram 3.
• (4250/4260) Wiring Diagram 22 and Wiring Diagram 24.
• (4265) Wiring Diagram 38 and Wiring Diagram 40.
Perform the following:
1. Remove all documents from the exit tray. Check that the out bin full sensor actuator, PL
10.15 Item 25 moves freely and is not damaged.
2. Enter dC330 code 08-720. Check the out bin full sensor (Q08-720), PL 10.15 Item 2.
3. (4150) Check the wiring between the out bin full sensor and CN6 on the Main PWB. If
necessary, install a new out bin full sensor, PL 10.15 Item 2.
4. (4250/4260) Check the wiring between the out bin full sensor and CN8 on the Main PWB.
If necessary, install a new out bin full sensor, PL 10.15 Item 2.
5. (4265) Check the wiring between the out bin full sensor and CN2 on the Main PWB. If
necessary, install a new out bin full sensor, PL 10.15 Item 2.
6. Enter dC330 code 04-200. Check that the exit motor (MOT04-200), PL 10.20 Item 2, runs
and drives the upper exit roll, PL 10.15 Item 23.
7. (4150) Check the wiring between the exit motor and CN12 on the Main PWB. Install new
components as necessary, PL 10.15 and PL 10.20.
8. (4250/4260) Check the wiring between the exit motor and CN13 on the Main PWB. Install
new components as necessary, PL 10.15 and PL 10.20.
9. (4265) Check the wiring between the exit motor and CN28 on the Main PWB. Install new
components as necessary, PL 10.15 and PL 10.20.
10. If necessary, install a new exit assembly, PL 10.15 Item 1.
11. Perform the OF5 Main PWB Check RAP.