Xerox WorkCentre 4150

January 2016
2-65
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
09-210, 09-220
Status Indicator RAPs
09-210 Toner Sensor RAP
09-210 The machine has detected that the toner sensor is not controlled.
Also use this RAP if the machine displays a Toner Sensor Error Replace Toner Cartridge mes-
sage.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Go to the relevant procedure:
• 4150 Checkout
• 4250/4260 Checkout
• 4265 Checkout
4150 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to Wiring Diagram 5. Perform the following:
1. Check the wiring between the xerographic module connector, PL 4.15 Item 17 and CN11
on the Main PWB. If necessary, install a new xerographic module connector, PL 4.15 Item
17.
2. Install a new xerographic module, PL 9.10 Item 1.
4250/4260 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to Wiring Diagram 23. Perform the following:
1. Check the wiring between the xerographic module connector, PL 4.15 Item 35 and CN11
on the Main PWB. If necessary, install a new xerographic module connector, PL 4.15 Item
35.
2. Install a new xerographic module, PL 9.10 Item 1.
4265 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to Wiring Diagram 39. Perform the following:
1. Check the wiring between the xerographic module connector, PL 4.15 Item 35 and CN22
on the Main PWB. If necessary, install a new xerographic module connector, PL 4.15 Item
35.
2. Install a new xerographic module, PL 9.10 Item 1.
09-220 Toner Expire RAP
09-220 The toner cartridge has reached the end of the design life of 20,000 (4150) or 23,000
(4250/4260) print pages.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Install a new toner cartridge, PL 9.10 Item 2.
NOTE: The toner expire message is based on a pixel count, not a signal from a sensor. It
cannot be reset by shaking the toner cartridge.