Xerox WorkCentre 4150

January 2016
2-66
WorkCentre WorkCentre 4150/4250/4260WorkCentre 4150/4250/42604150/
09-230, 240, 250, 500, 09-270, 271
Status Indicator RAPs
09-230, 240, 250, 500 Toner Cartridge Communications
Error RAP
09-230 The toner cartridge CRUM failed to write to the CRUM PWB.
09-240 The machine failed to communicate with the toner cartridge CRUM.
09-250 The machine detected a toner cartridge read error.
09-500 The toner cartridge is not installed or is not detected by the CRUM PWB.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Go to the relevant procedure:
• 4150 Checkout
• 4250/4260 Checkout
4150 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to Wiring Diagram 5. Perform the following:
1. Check that the toner cartridge, PL 9.10 Item 2 is installed correctly.
2. Remove the toner cartridge. Check the CRUM contact on the toner cartridge.
3. Check the wiring between the CRUM PWB, PL 4.15 Item 15 and CN11 in the Main PWB.
4. Install new components as necessary:
• Toner cartridge, PL 9.10 Item 2.
• CRUM PWB, PL 4.15 Item 15.
5. Perform the OF5 Main PWB Check RAP.
4250/4260 Checkout
NOTE: The main PWB has test points. The location of the test points is shown on the Main
PWB PJ location illustration.
Refer to Wiring Diagram 23. Perform the following:
1. Check that the toner cartridge, PL 9.10 Item 2 is installed correctly.
2. Check the wiring between the toner CRUM socket, PL 4.15 Item 33 and CN11 in the Main
PWB.
3. Install new components as necessary:
• Toner cartridge, PL 9.10 Item 2.
• Toner CRUM socket, PL 4.15 Item 33.
4. Perform the OF5 Main PWB Check RAP.
09-270, 271 ID Sensor Fault RAP
09-270 The machine has detected that the ID sensor has a fault.
09-271 The machine has detected that the ID sensor is contaminated.
Procedure
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
Refer to Wiring Diagram 25. Perform the following:
1. Clean the ID sensor, PL 7.35 Item 31.
2. Check the wiring between the ID sensor and CN17 on the Main PWB.
3. Install new components as necessary:
• ID sensor, PL 7.35 Item 31.
• Side cover assembly, PL 7.30 Item 1.
4. Perform the OF5 Main PWB Check RAP.